Pared móvil

The movable bulkhead allows simultaneous activities to take place inside separate areas of the same swimming pool. Built in stainless steel, the structure can be drawn across the width of the pool using two rails, located externally on the floor surface. The sliding movement is made possible by using two stainless steel flywheels located on the two opposite ends of the bulkhead. Flywheels are connected to the sliding system through a double chain reduction gear.

 

The movable bulkhead allows simultaneous activities to take place inside separate areas of the same swimming pool. Built in stainless steel, the structure can be drawn across the width of the pool using two rails, located externally on the floor surface.

The sliding movement is made possible by using two stainless steel flywheels located on the two opposite ends of the bulkhead. Flywheels are connected to the sliding system through a double chain reduction gear.

The “split-in-two” movable bulkhead

The “split-in-two” movable bulkhead is an extraordinary FINA approved swimming pool component which allows to turn the pool into a multipurpose aquatic area where you can perform different activities at the same time, either training or leisure. This type of swimming pool movable bulkhead can be split in two halves, giving the pool the chance to have more configurations than what is possible with the usual bulkheads.

The Flow-Through Bulkhead

Flow through bulkheads allow a large amount of the swimmer’s surge wave to pass through the bulkhead above and below the water, helping reduce the rebound wave and turbulence.

Contact


This field is required
This field is required

Insertar un dirección valido
This field is required

Ingrese un código postal válido
This field is required
Escribe aquí tu mensaje
This field is required

Enviado!!